Reject unstable 768 continuation tile baseline

This commit is contained in:
Morpheus
2026-10-11 13:13:26 +00:00
parent e0d54f5baa
commit 48ddc86003
3 changed files with 8 additions and 8 deletions
@@ -109,8 +109,8 @@ These are the valid runs recorded so far. Runtime is wall-clock generation time;
**SLU-19 remains the fastest validated single-clip baseline**: 672×384 initial generation, 1024×640 tiles in a 2×2 layout, 96-pixel overlap and a 1920×1088 output. It was reviewed and accepted with good quality and no visible seams. At 18m 11s it is below the 20-minute target and has the best normalized throughput so far at 8.71 min/Mpx.
**Pinned continuation setting:** use 768×768 tiles in a 2×3 layout with 96px overlap for sequential continuation clips. The 1024×640 layout ran out of VRAM when continuation context was present on the RTX 3070, while 768×768 is the validated lower-memory fallback and is now the default for multi-clip work. Keep the 1024×640 result as a single-clip performance record, not the continuation default. The attention `keep_percent 5` test was slower at 31m 05s, so the baseline value of 10 remains in use.
The attention `keep_percent 5` test was slower at 31m 05s, so the baseline value of 10 remains in use.
SLU-09 full-frame/no-split failed with GPU out-of-memory on the 8 GB card and is not a viable baseline. The tracked `workflow.json` now uses the pinned 768×768 continuation settings. Static prompt, seed, references, model, samplers, schedulers, steps, denoise and final target remain unchanged.
SLU-09 full-frame/no-split failed with GPU out-of-memory on the 8 GB card and is not a viable baseline. The tracked `workflow.json` uses the SLU-19 settings. Static prompt, seed, references, model, samplers, schedulers, steps, denoise and final target remain unchanged.
The earlier tile submissions that produced 1024×1024 output are excluded from this table because their target-resolution override was not applied. The current baseline uses 96px overlap; further reductions should only be attempted if a visible-seam comparison is worthwhile.
@@ -1919,10 +1919,10 @@
"widgets_values": [
1920,
"specific_size",
768,
768,
1024,
640,
2,
2,
3,
96,
96,
64,
@@ -508,10 +508,10 @@
0
],
"tile_size_mode": "specific_size",
"tile_width": 768,
"tile_height": 768,
"tile_width": 1024,
"tile_height": 640,
"grid_rows": 2,
"grid_cols": 3,
"grid_cols": 2,
"spatial_w_overlap": 96,
"spatial_h_overlap": 96,
"fade_width": 64,